DPF 5000 4-MIL ENGINEERED VINYL FILM, LOW TACK POSITIONABLE ADHESIVE
Engineering Grade Digital Print Pressure Sensitive Film
- DPF 5000 is a 3.8-mil satin white, high-tensile, polyvinyl chloride film with repositionable, permanent pressure-sensitive adhesive.
- Designed for indoor and outdoor graphics, DPF 5000 is made of 100% polymeric face stock with a special lay-flat liner.
- DPF 5000 is designed to meet the marking requirements and specifications of the transportation, vending, and automotive industries.
- The film conforms well to flat surfaces with slight contours when processed and applied according to Arlon recommendations.
- DPF 5000 is rated for outdoor durability up to 7 years (unprinted). Printed durability is dependent on the ink system used.
AREAS OF USE
- Digital printing with a wide variety of direct print systems;
- Fleet and container markings and display graphics;
- Decorations for railway car, bus, boat, and recreational vehicles, POP displays, vending machines, and architectural graphics.
PERFORMANCE AND PHYSICAL DATA
TYPICAL VALUE:
40-60%
0.0051 in 0.13 mm
13.0 lb/in width 2.3 kg/cm width
100%
1 year from factory shipment
40°F to 100°F optimum
4.4°C to 38°C optimum
-20°F to 175°F -29°C to 79°C
15 mils 0.38 mm
3.5 lbs/in 0.63 kg/cm
30 g/2 in 12 g/cm
TEST METHODS:
Gloss Meter 60° Reflection
Micrometer, Federal Bench Type
Tensile tester with 2-in (51 mm)
jaw separation; crosshead speed of
12 in/min. (5.1 mm/s), web direction
Instron tensile Tester as above
Free from excessive moisture,
temperature, direct sunlight
On clean, dry substrate
On clean, dry substrate
158°F (70°C), 48 hours
PSTC-1, 15 min, RT 70°F (21°C)
TLMI Release at 90°, 300 in/min
760 cm/min)
PROPERTY
Surface Finish
Thickness
including adhesiveTensile strength
Elongation
Shelf life
Application Temperature Range
Service Temperature Range
Dimensional Stability
Peel adhesion
Liner release
CONDITIONS OF SALE
The following is made in lieu of all warranties expressed or implied:All statements, technical information and recommendations published by Arlon, Inc. relating to PDF products are based on tests believed to be relative and within the accurary of the equipment used to obtain the specific values. Their accuracy or completeness is not guaranteed and Arlon, Inc. makes no warranty with regard threreto. Seller's and manufacturer's only responsibility shall be replace any quantity of the product proved defective. Seller and manufacturer shall not be liable for injury, loss or damage, direct or consequential, arising out of use or the inability to use the product. Nor shall seller or manufacturer be liable for any costs or expenses incurred in the processing or printing on the product. Before using user shall determine the suitability of the product for its intended use. User assumes all risk and liability of every nature in connection therewith. No statements or recommendations other than those contained in the technical information published by Arlon, Inc. shall have force or effect unless contained in an agreement manually signed by the officeres of seller and manufacturer.
www.ppmsupplies.nl